FriendsOffice store. Sanitizing Wipes

Usage Instructions TO SANITIZE hard, nonporous non-food contact surfaces: Wipe surface; use enough wipes for treated surfaces to remain visibly wet for 30 seconds. Let surface dry. For highly soiled surfaces, clean excess dirt first. TO CLEAN: Wipe surface clean with Clorox Multi-Purpose Paper Towel Wipes. Let air dry. This product will not harm most surfaces including acrylic, sealed fiberglass, sealed granite, finished hardwood and vinyl. Not recommended for use on unpainted wood and unfinished, unsealed, unpainted, waxed, oiled or worn surfaces.

Open and Reuse Resealable Pouch: Open pouch by peeling back seal. Use wipes as directed. Reseal pouch after each use to retain moisture. Usage Directions: Pull wipe from pouch and use to clean surfaces such as wood, laminate, electronics, chrome, glass, mirrors and metal. If using on electronic equipment, follow the manufacturer's instructions. Before using on an unknown surface, test on an inconspicuous area. For greater shine on your wood, please use Pledge® Moisturizing Oil.

<ul> <li>Clean and disinfect high-touch surfaces in just ONE Minute</li> <li>Non-irritating to eyes and skin</li> </ul>

<ul> <li>Ensure the EasyWipe Disposable Wiping System is compatible with the desired type of chemical solution. Read Safety Data Sheet (SDS) and test the chemical solution with the wipes to determine compatibility.</li> <li>Understand any hazards related to the chemical solution and its use by consulting its SDS. Follow all applicable safety advice and use appropriate protective equipment. For questions about safe chemical solution use, contact your supervisor or site occupational safety professional.</li> <li>Fill out the label with all information about the added chemical solution or apply the appropriate aftermarket label to the bucket. Note: This label does not replace the manufacturer or supplier's SDS.</li> <li>Slowly pour chemical solution over the top of the roll. Use approximately one half gal. (74 oz. / 1.9 L) of chemical solution in the 1 gal. (3.78 L) bucket. More or less liquid may be required to obtain the desired saturation level.</li> <li>Thread the end of the wiper from the CENTER of the roll through the lid opening. Snap the lid on.</li> </ul>

<ul> <li>Pre-clean heavily soiled areas.</li> <li>Wipe hard, non-porous environmental surfaces with towelette.</li> <li>Allow surface to remain wet for 1 minute. (For certain listed viruses, allow to remain wet for 30 seconds).</li> <li>Air Dry, wipe surfaces to dry and remove any residue, or rinse with potable water as necessary.</li> </ul>

Special Instructions for Using This Product to Clean and Decontaminate Against HIV-1, HBV and HCV on Surfaces/Objects Soiled with Blood/Body Fluids: Personal Protection: When handling items soiled with blood or body fluids, use disposable impervious gloves, gowns, masks and eye coverings. Cleaning Procedure: Blood and other body fluids must be thoroughly cleaned from surfaces and other objects before applying this product. Contact Time: Allow surfaces to remain wet for 1 minute, let air dry. For all other organisms, see directions for contact times. Disposal of Infectious Materials: Use disposable impervious gloves, gowns, masks and eye coverings. Blood and other body fluids must be autoclaved and disposed of according to local regulations for infectious waste disposal.

Sanitizing Wipes

Clorox On The Go Bleach-Free Disinfecting Wipes